A Guide To Do It Yourself Garage Installation

The task of doing a garage installation has the potential to turn out difficult. This has to do with the heaviness of the door, which can make it harder to do. However, those who are good at doing things themselves will find it more rewarding than a hassle.

One thing to keep in mind, relates to the type of spring system that the door uses. In most cases you are not going to do the job if it utilizes a standard spring mechanism. Generally, the only kind you should work with is a torsion spring system. Also, you should keep this in consideration as well, while thinking about removing a door.

Throughout the time you are installing your sectional garage door, make sure to follow any other directions that came with the door. To start, apply weather stripping on the bottom part of the first panel. Use something such as nails to keep the door temporarily in place. Assemble the tracks according to the directions you have.

Install any brackets needed in addition to the rollers and brackets on the door section. The vertical tracks are the next things that you should put in after the rollers.

With the next section, you are really going to need someone to help you. At this point you need to lift the door and place it so it fits. After, put the rollers in and follow with the installation with the vertical tracks on each side. Attach the first section of the door to the second with the hinges. When you put in the third section, you should do it as you did the last section.

Check your work by referencing the instructions that you have. Seeing that everything is ok, then start with the installation of the top plates. These are attached to the wall for the vertical tracks on both sides of the door. During the time of installation, make sure its tight.

When you attach the track hangers, ensure that it is to something that is solid, like a ceiling joist. In a loose manner, then attach the track on both sides to the hanger. After this, put the last section of the door in and then proceed to removal of any nails that were used for temporary purposes. The next part will depend on whether you are planning to use a door opener. In the case that you are not then you can proceed with installing the torque tube. When you put this in, follow the directions that came with the door. In order to check the alignment of the door, open the door about 4 feet and make any adjustments according to what is needed. The very last thing that you are going to want to do is make sure that everything is tight, then enjoy.

Learn more about garage door repair. Stop by Danny Signal’s site where you can find out all about Houston Garage Door and what we can do for you.